設備由進瓶輸送線，模具輸送線，放模具裝置，壓提環裝置，取模具裝置，模具，定位裝置，架體，控制系統等組成。設備動作分為放提環、放模具、壓提環、取模具四個基本動作完成。首先由人工將提環放在模具上，然后由模具輸送線輸送至放模工位，放模裝置將三個模具放在另個瓶子上，再由進瓶輸送線將瓶子輸送至壓提環工位。壓完提環后由取模裝置將模具取放至模具輸送線上，由模具輸送線將模具輸送至放提環工位循環使用。放模、壓提環、取模工位瓶子均有定位裝置將瓶子定位。

詳細介紹

設備由進瓶輸送線，模具輸送線，放模具裝置，壓提環裝置，取模具裝置，模具，定位裝置，架體，控制系統等組成。
設備動作分為放提環、放模具、壓提環、取模具四個基本動作完成。首先由人工將提環放在模具上，然后由模具輸送線輸送至放模工位，放模裝置將三個模具放在另個瓶子上，再由進瓶輸送線將瓶子輸送至壓提環工位。壓完提環后由取模裝置將模具取放至模具輸送線上，由模具輸送線將模具輸送至放提環工位循環使用。放模、壓提環、取模工位瓶子均有定位裝置將瓶子定位。

技術參數

生產速度：1200PCS/小時

適用產品：6L醬油瓶

氣源：壓縮空氣氣壓0.6Mpa以上

電源：AC220V，50Hz

功率：約1000W

The equipment is composed of bottle feeding conveying line, mold conveying line, mold releasing device, pressure lifting ring device, mold taking device, mold, positioning device, frame, control system, etc.
The equipment action is divided into four basic actions: releasing the lifting ring, releasing the mold, pressing the lifting ring and taking the mold. Firstly, the lifting bail is put on the mold manually, and then transported to the mold releasing station by the mold conveying line. The mold releasing device puts three molds on another bottle, and then the bottle is transported to the pressure lifting bail station by the bottle feeding conveying line.
After pressing the bail, the mold is taken and placed on the mold conveying line by the mold taking device, and the mold is transported to the bail placing station by the mold conveying line for recycling. There are positioning devices for the bottles in the mold release, pressure lifting ring and mold taking stations to position the bottles.

technical parameter

Production speed: up to 1200pcs / h

Applicable product: 6L soy sauce bottle

Air source: compressed air pressure above 0.6MPa

Power supply: AC220V, 50Hz

Power: About 1000W