BXM51防爆照明配電箱，BXM51-7K/8K/9K防爆配電箱（明裝/掛壁式）

BXM51系列防爆照明配電箱（以下簡稱防爆配電箱）是按GB3836.1～2設計和制造，配電箱主要用于1區或2區中含有爆炸性混合物為Ⅱ類B級T4組及以下爆炸危險場所，作為交流50Hz，額定電壓至380V，分支回路額定電壓220V或380V，分支回路額定電流至60A的電路中，作不頻繁接通與分斷之用，且具有過載和短路保護。

 BXM（D）-4                                                      4                                           1                          
  BXM（D）-6                                                      6                                           3
  BXM（D）-8          380                63                   8                                           5
  BXM（D）-10                                                   10                                         10  
  BXM（D）-12                              ~                   12                                         15                                  G11/4"   G1/2"         Φ12       Φ8                    IP55
  BXM（D）-4K                                                   4                                          20          Exde II CT6       ~             ~                 ~            ~                     *IP65
  BXM（D）-6K                                                   6                                          25                                   G3"       G1'/2"        Φ56    Φ 26
  BXM（D）-8K        220              250                 8                1                        40
  BXM（D）-10K                                                 10                                        50
  BXM（D）-12K                                                 12                                        60

外形及安裝舉例 Outline and mounting example
   
BXM（D）-4                          BXM（D）-4K 
   
BXM（D）-6                          BXM（D）-6K 
   
BXM（D）-8                          BXM（D）-8K 
   
BXM（D）-10                         BXM（D）-10K 
   
BXM（D）-12                         BXM（D）-12K 
       
--------------------------------------------------------------------------------
            支路數                                                  L                                 A
            Branch number
--------------------------------------------------------------------------------
     4 回路 FOUR CIRCUITS                       920                              390
--------------------------------------------------------------------------------
      6 ,  8 回路 Six eight circuits                 1055                             640
--------------------------------------------------------------------------------
     10 , 12 回路 Ten,twelve circuits          1430                             890
--------------------------------------------------------------------------------
 
BXM（D）-8K（IIC）  
   
BXM（D）-6                             BXM（D）-4
   
BXM（D）-6K                           BXM（D）-4K 

BXM51防爆照明配電箱產品型號和意義及基本參數
The product model and the significance and basic parameters
產品型號和意義
The product model and the significance
BXM 51- □□□□□
BXM 51- □ □ □
WF：戶外防中腐蝕（不要求不注）
WF: outdoor prevent corrosion （does not require no note）
出線口方向 D：上出線 X：下出線
Outlet directions D: X: lower outgoing line
進線口方向 D：上進線 X：下進線
The inlet direction of D: X: motivated line into the line
K:主回路帶總開關（不帶不注）
K: main loop with a total switch （without note）
支路數
The number of branch
設計序號
Design of serial number
防爆照明配電箱
Explosion-proof lighting distribution box
基本參數
Basic parameters
配電箱基本參數見下表
The basic parameters of the distribution box shown in the table below
型號 額定電壓（V） 支路額定電流A 饋電開關電流
Model voltage （V） branch rated current A feed switch current
A 回路數
A circuit number
主回路 支路
The main loop circuit
BXM51 380 220 5;10;15;20;3240;50;60 10;15;20;25;3240;50;60;80;100140;200;250 2;4;6;8;10;
BXM51 3802205; 10; 15; 20; 3240; 50; 6010; 15; 20; 25; 3240; 50; 60; 80; 100140; 200; 2502; 4; 6; 8; 10;
12
12
380
380
BXM51防爆照明配電箱的防爆標志為dⅡBT4;
Explosion-proof 3 distribution box sign D Ⅱ BT4;
2．4配電箱進線配用電纜zui大外徑為26mm；
The 2.4 lines into the cable distribution box with the largest diameter of 26mm;
2．5配電箱出線配用電纜zui大外徑為15mm；
2.5 wire cable distribution box with the largest diameter of 15mm;
3 配電箱在下列情況下能夠可靠工作
3 distribution box can work reliably in any of the following circumstances
3．1 周圍空氣溫度上限值不超過+40℃，下限值不低于-20℃，且24小時內的平均值不超過+35℃；
3.1 the temperature of the air around the upper limit of not more than +40 ℃, lower value not lower than -20 ℃, and within 24 hours of the average value of not more than +35 DEG c;
3．2 安裝地點的海拔不超過2000m；
3.2 installation site elevation not exceeding 2000m;
3．3 在無顯著搖動、振動和沖擊的地方；
3.3 significant shake, no vibration and shock;
3．4 安裝地點zui濕月平均zui大相對濕度不超過95%，同時該月的月平均溫度不低于+25℃；
3.4 installation location the wettest month average maximum relative humidity of not more than 95%, while the average monthly temperature of the month is not lower than +25 ℃;
3．5 污染等級為3級；
3.5 of the pollution level of 3;
3．6 安裝類別為Ⅱ、Ⅲ類；
3.6 installation of class II, class iii;
3．7 防護等級：IP54。
3.7 protection grade: IP54.
BXM51防爆照明配電箱主要結構
The 4 main structure
配電箱外殼采用ZL102鑄鋁合金制成隔爆型主腔及接線腔，主腔內裝有C45N系列斷路器，通過操作機構及外殼手柄進行操作，每回路有“分”、“合”指示，且有指示燈顯示，接線腔內有與主腔相貫通的接線端子，并有電纜引入裝置，設有內外接地螺釘。
Distribution box shell is made of ZL102 cast aluminum alloy made of explosion-proof main cavity and a wiring cavity, the cavity is provided with a C45N series circuit breaker, operated by the operating mechanism and the shell handle each loop, "", "" instructions, and indicator light shows, with the main cavity intersecting terminals through the wiring cavity, and the cable leading-in device, with internal and external grounding screw.
BXM51防爆照明配電箱使用與維修
5 use and repair
5．1 將配電箱安裝固定好，將進出線腔蓋打開，把電纜通過引入裝置接至接線端子上，接好內外接地線，檢查無誤后合上蓋，用緊固件緊固，并把壓緊螺母旋緊使電纜密封，完畢后即可使用。
5.1 the distribution box installation fixed, pass in and out line cavity cover is opened, the cable introducing device connected to the terminals, connected inside and outside the ground, check and correct after the upper cover, with the fastening piece, and the pressing nut is screwed up the cable sealing, can after use.
5．2 配電箱不得隨意拆卸，維修進先斷開電源后，才能開蓋維修，維修時不得損壞隔爆面，維修后隔爆接合面涂204-1防銹油，并將蓋合好，用螺栓緊固后才能使用。
5.2 distribution box shall not disassemble, repair in first disconnect the power, in order to open repair, repair shall not be damaged flameproof surface, after the repair of flameproof joint 204-1 coated anti-rust oil, and will cover good, used to bolt after.
5．3 配電箱安裝傾斜度不超過5°。
5.3 distribution box installation inclination of not more than 5 °.